Cisco ONS 15454 Troubleshooting Manual page 54

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6220 Invalid Ethernet speed value
EID-6221 Invalid mtu value
EID-6222 Invalid flow control value
EID-6223 Invalid Network Interface Mode
EID-6224 Invalid ingress COS value
EID-6225 Invalid ethertype value
EID-6226 Invalid buffer size value
EID-6227 Invalid egress QOS value
EID-6228 Invalid QinQ working Mode
EID-6229 Configured protection status Not Supported
EID-6230 The number of provisioned entries exceeds the limit
EID-6231 This is not a valid VLAN ID.
EID-6232 The VLAN remapping ID is not allowed.
EID-6233 The CVLAN is duplicated.
EID-6234 The VLAN ID is out of range.
EID-6235 This is not a valid VLAN name.
EID-6236 The protected VLAN number exceeds the maximum allowed.
EID-6237 The port is not in OOS disabled admin state
EID-6238 The VLAN ID is in use.
EID-6239 APC wrong node side.
EID-6240 You cannot change the Admin State for an interlink port when
it is part of an ADM peer group. This operation is not
supported.
EID-6242 The protection slot is invalid.
EID-6243 The {0} address of {1} is invalid.
EID-6244 The mask of {0} is invalid.
EID-6245 The cost must be between 1 and 32767.
EID-6246 The {0} address cannot be {1}.
EID-6247 The authentication type is invalid.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-54
Chapter 4
Description
The Ethernet speed value is invalid. Enter
again.
The MTU value is invalid. Enter again.
The flow control value is invalid. Enter
again.
The network interface mode value is
invalid. Enter again.
The ingress COS value is invalid. Enter
again.
The Ethertype value is invalid. Enter again.
The Buffer size value is invalid. Enter
again.
The egress QOS value is invalid. Enter
again.
The QinQ working mode is invalid. Enter
again.
The protection status is not supported
Refer to the error message text.
Entered VLAN ID is not present in the
database file.
Refer to the error message text.
You cannot have identical CVLAN IDs.
The VLAN ID entered is out of range.
The entered VLAN name exceeds the
number of characters (32) allowed.
The user enters more than 256 protected
VLAN in the VLAN database.
Refer to the error message text.
The entered VLAN ID is in use by a node.
Refer to the error message text.
Refer to the error message text.
You must select a valid protection slot.
Refer to the error message text.
The mask of the specified value is not valid.
Refer to the error message text.
Refer to the error message text.
Enter a valid authentication type.
Error Messages
78-19418-01