Checking The Operating Status - Cisco Prisma II Installation And Operation Manual

Checking the Operating Status

Introduction
Using the LCI software, you can check the status of all operating parameters of the
bdr Transmit Processor.
Monitored Parameters
The table below describes the monitored parameters for the bdr Transmit Processor.
Parameter
Module 1.8 Voltage
Module 3.3 Voltage
Module Temperature
Transmitter 1 Laser Bias
Transmitter 2 Laser Bias
Transmitter 1 Installed
Transmitter 2 Installed
Transmitter 1 Type
Transmitter 2 Type
Transmitter 1
Temperature
Transmitter 2
Temperature
78-715192-01 Rev C
Units Function
V 1.8 Voltage level internal to the processor.
V 3.3 Voltage level internal to the processor.
°C Displays
mA Displays laser 1 bias current.
mA Displays laser 2 bias current.
Yes/ Indicates if transmitter sub-module 1 is
No installed.
Yes/ Indicates if transmitter sub-module 2 is
No installed.
0 or 3 Indicates what type transmitter is installed.
0 = 1550 nm cooled laser transmitter sub-
module
3 = Uncooled 1550 nm or 1310 nm laser
transmitter sub-module
0 or 3 Indicates what type transmitter is installed.
0 = 1550 nm cooled laser transmitter sub-
module
3 = Uncooled 1550 nm or 1310 nm laser
transmitter sub-module
°C Displays
temperature.
°C Displays
temperature.
Operation Using the LCI Software
temperature.
processor
transmitter sub-module 1
transmitter sub-module 2
4-17