Cisco Prisma II Installation And Operation Manual page 36

Overview
Introduction
The procedures in this chapter apply if you are using the Prisma II Intelligent
Communications Interface Module (ICIM) to configure and operate the Prisma II bdr
2:1 Redundant Transmit Processor.
Scope of This Chapter
Included in this chapter are descriptions of the ICIM front panel and the ICIM LCD,
and detailed procedures on how to use the software menus to configure the
transmitter.
In This Chapter
This chapter contains the following topics.
ICIM Introduction
The ICIM Front Panel
The ICIM Password
Operating the ICIM
Monitoring Operating Status Using the ICIM
Configuring the Prisma II bdr Transmit Processor Using the ICIM
Checking bdr Transmit Processor Alarms Using the ICIM
Checking Manufacturing Data Using the ICIM
Using the ICIM to Save the Configuration
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
78-715192-01 Rev C
Chapter 3
Operation Using the ICIM
Topic
Operation Using the ICIM
See Page
3-2
3-3
3-6
3-12
3-16
3-20
3-23
3-29
3-32
3-1