Connecting Power And Booting The System; Checking The Leds - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Connecting Power and Booting the System

Figure 3-6
1
1
2
3
Connecting Power and Booting the System
To connect power to your system, follow these steps:
Review the information in the
Step 1
Step 2 Plug a power cord into the power cord receptacle on the back of the WAVE appliance.
Step 3 Connect the other end of the power cord to a power source at your installation site.
Step 4 Power up all externally connected devices.
Press the power control button on the front of the WAVE appliance.
Step 5
The system should begin booting. Once the operating system boots, you are ready to initialize the basic
software configuration. (See the software configuration guide for details.)
Note

Checking the LEDs

When the WAVE-594 and WAVE-694 is up and running, observe the front panel LEDs (see
and
To troubleshoot using the LEDs, see
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
3-8
Cable Connections—Front
3 4
2
Console port (mini-USB)
Console port (RJ-45)
10/100/1000 GE 0/0 connector
While the WAVE appliance is powering up, the green power-on LED on the front of the
appliance is on.
Table 1-1) to verify that your system is operating properly.
5
4 10/100/1000 GE 0/1 connector
5
External USB port
"Safety Guidelines" section on page
Chapter 6, "Troubleshooting the System Hardware."
Chapter 3 Installing the WAVE-594 and WAVE-694
2-2.
Figure 1-1
OL-24619-02