Accessing The Device Details Window - Cisco Prisma II Installation And Operation Manual

Hide thumbs Also See for Prisma II:

Table of Contents

Accessing the Device Details Window

Introduction

Information about a device (its parameters, alarms, and status) is located in the

Device Details window. The graphic below shows the Device Details window for a

Prisma II bdr Transmit Processor.

Within the LCI device tree, you can access this window using one of the following

four methods:

• Double-click the chassis and select the device in the graphic that displays

• Right-click the chassis and select Open from the menu that displays

• Double-click the module

• Right-click the device and select Details from the menu that displays

Note: Although you can use the method that's most convenient for you, the

procedures throughout this chapter are described using the right-click device

technique.

For more information about the device tree, refer to LCI Device Tree Overview

earlier in this chapter.

4-14

Operation Using the LCI Software

78-715192-01 Rev C

Table of Contents