Cisco Prisma II Installation And Operation Manual page 30

Connecting Optical Cables,
Using the Fiber Fish to Pull the Optical Cable to the Prisma II Module
Important: Use a protective cap to protect the end of the fiber while the fiber is being
fished (or handled in general).
To pull the optical cable to the module, follow these procedures.
1. Insert the Fiber Fish tool through the slot located just above the bottom of the
chassis.
2. At the rear of the chassis, locate the appropriate optical cable.
3. Insert the optical cable into notched area of the Fiber Fish tool as shown.
4. At the front of the chassis, pull the Fiber Fish tool (with cable attached) to the
front of the chassis.
5. Disengage the optical cable from the Fiber Fish tool and remove the protective
cap.
6. Attach the optical cable to the appropriate connector on the processor front
panel. See Cable Connection Procedure.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
2-10
Continued
Installation 78-715192-01 Rev C