Preparing For Installation - Cisco Prisma II Installation And Operation Manual

Preparing for Installation

Overview
Before you begin, make sure that the module is in good condition and that you have
the tools and equipment listed here.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. If you find any damage,
contact Cisco. Refer to Chapter 6 for information on contacting Cisco's for technical
assistance.
Equipment and Tools Needed
Before you begin, make sure that the module is in good condition. You need the
following equipment and tools to install these modules.
You need . . .
a Prisma II Chassis with power supply provide housing, power and input/output
3/8-in. flat-blade screwdriver
two RF cables with F-type connectors
2-2
To . . .
connections to the module.
secure the module in the chassis.
carry RF input signals.
Installation 78-715192-01 Rev C