Laser Safety - Cisco Prisma II Installation And Operation Manual

Laser Safety

Introduction
This product contains an infrared laser that transmits intensity-modulated light and
emits invisible radiation.
Warning: Radiation
WARNING:
• Avoid personal injury! Use of controls, adjustments, or procedures other than
those specified herein may result in hazardous radiation exposure.
• Avoid personal injury! The laser light source on this product emits invisible
laser radiation. Avoid direct exposure to the laser light source.
Do not apply power to this product if the fiber is unmated or unterminated.
•
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
•
light that is emitted from an unterminated fiber.
Do not view an activated fiber with optical instruments.
•
Warning: Fiber Chips
WARNING:
Avoid personal injury! Wear safety glasses and use extreme caution when you
handle the glass chips that are inside the cladding of the optical fiber. X-ray
cannot detect these glass chips if they become embedded in the skin. Place the
chips immediately in a small waste container and discard.
Modifications
Do not make modifications to this product without the approval of Cisco.
Whenever modifications that may affect hazard levels are made to the optical fiber
communication system, the person or organization that performs such modification
must reassess hazard levels. They must do this by conducting tests and
measurements wherever appropriate for the ensurance of compliance. If there is a
change in the hazard level, they must re-label this product.
viii 78-715192-01 Rev C