Configuring The Bdr Transmit Processor - Cisco Prisma II Installation And Operation Manual

Configuring the bdr Transmit Processor

Introduction
Using the LCI software, you can configure the parameters listed below.
Configurable Parameters
Configurable parameters for the Prisma II bdr Transmit Processor are listed below.
Parameter
Redundant
Mode
RF Drive
Stream A
RF Drive
Stream B
Clock Source
Noise
Suppression
Transmitter 1
Enable
Transmitter 2
Enable
78-715192-01 Rev C
Function
The typical number of
transmitters to be used in
this unit. No, if there is
typically 1 transmitter.
Yes, if there are typically
2 transmitters. If set to
No, no alarm is generated
when the second
transmitter is removed.
Amount of attenuation on
input A
Amount of attenuation on
input B
Master, Slave, or
Independent
Controls noise
suppression
Enables or disables
transmitter 1 operation
Enables or disables
transmitter 2 operation
Operation Using the LCI Software
Values
Yes or No
0 dB to 10.0 dB in 0.1 dB
increments
0 dB to 10.0 dB in 0.1 dB
increments
Indpend - Transmitter
generates the clock
signal but does not send
it outside the module.
Master - Transmitter
generates it's own clock
signal and sends it out.
Slave - Uses the clock
input supplied from the
backplane, typically
from another transmitter
in Master mode. If the
clock is not present clock
alarms are generated.
On or Off
Enable/Disable
Enable/Disable
Default
Yes
0.0 dB
0.0 dB
Independ
On
Enable
Enable
4-19