Cisco Prisma II Installation And Operation Manual page 32

Installing Sub-Modules in the Processor
Installing the Sub-Module
Important! For best results, install the Prisma II bdr Transmit Processor into the
Prisma II Chassis before installing the transmitter sub-modules into the processor.
To install the sub-module in the processor, follow these steps.
1. Align the ridges on the top and bottom of the transmitter sub-module with
the guide slots located on the processor.
2. Gently slide the sub-module into the processor until you feel the power and
communications connections on the back of the module join connectors on the
processor. Use the thumbscrew on the top of the sub-module to lock the sub-
module in place.
2-12 Installation 78-715192-01 Rev C