Table of Contents
Advertisement
TURNING ON THE SERVER
Turn on the server and follow the on-screen instructions.
IMPORTANT:
Some optional boards require additional setup with the SETUP utility before installation.
If the server has a PCI board with the PCI-to-PCI bridge installed, the SETUP utility
cannot be started. Check the board specifications to find out whether it requires
pre-installation setups before actually installing the board.
Some installed optional devices or connected peripheral devices require setups before
proceeding to the next step.
To use the server with no optional devices installed besides the graphic board, install the
desired OS to the server.
1.
Make sure that the floppy disk drive contains no floppy disk and that the CD-RW/DVD-ROM drive contains
no bootable CD/DVD-ROM.
2.
Press the POWER/SLEEP switch.
NOTES:
If the power cord is connected to a power control unit such as a UPS, turn on the power
control unit.
Connect the power cord and wait for about 30 seconds before pressing the
POWER/SLEEP switch to allow the BMC (Baseboard Management Controller)
firmware start-up.
Before turning on the server:
POWER/SLEEP switch
POWER/SLEEP LED
3-21
Advertisement
Table of Contents
