Table of Contents
Advertisement
Hot Add
Follow the procedure below to execute a Hot Add:
1.
Pull out the server from the rack (without powering off the server).
2.
Remove the top cover.
3.
Locate the slot in which you are going to install an additional board.
NOTE:
Confirm that the PCI Slot Power LED of the slot in which you are going to install
the PCI board is off.
4.
Open the protection plate.
5.
Push the tab at the tip of the additional slot cover to unlock the tab. Open the tab.
IMPORTANT:
could damage the tab.
Do not open the retention tab to an angle of 90 degrees or more. Doing so
9-26
Advertisement
Table of Contents
