Table of Contents
Advertisement
STATUS LED
Description
indication
Unlit
The server is powered off.
POST is in progress.
A processor error occurred
(IERR).
A processor thermal error
was detected. (Thermal-Trip)
A watchdog timer has timed
out.
A PCI system error occurred.
A PCI parity error occurred.
An uncorrectable memory
error was detected.
An uncorrectable bus error
was detected.
POST terminates with error.
Memory dumping is
requested.
Lit in amber
A thermal error (critical) was
detected.
A voltage error (critical) was
detected.
Flashing in
A power alarm was detected
amber
in a power supply unit.
A fan alarm was detected.
A thermal error (warning)
was detected.
A voltage error (warning) was
detected.
A hard disk drive failed.
Action
Power on the server.
Wait for a while. The STATUS LED will turn on a
few seconds after the POST completion.
Cycle power to the server. If POST displays an
error message, note the message and contact
your service representative.
Wait until the memory dump is completed.
Check the internal fans for dust or debris.
Make sure that the fans are firmly connected.
If this error indication persists, contact your
service representative.
Contact your service representative.
Identify the failed power supply unit and contact
your service representative.
Check the internal fans for dust or debris.
Make sure that the fans are firmly connected.
If this error indication persists, contact your
service representative.
Check the internal fans for dust or debris.
Make sure that the fan are firmly connected.
If this error indication persists, contact your
service representative.
Contact your service representative.
If the hard disk drives are in RAID configuration
(RAID1, RAID5, RAID6, RAID10, or RAID50), a
single failed hard disk drive does not affect the
operation of the server. However, we
recommend you replace the failed hard disk
drive and auto-rebuild (reconfigure) the hard disk
drives as soon as possible. (You can hot-swap
such a failed hard disk drive.)
8-5
Advertisement
Table of Contents
