5-inch Device
The server has one slot for a backup device such as a magnetic tape drive.
Available Devices
The 5-inch device slot can contain a single-height SCSI device or a USB device.
Setting of the SCSI ID when using a SCSI device
Refer to the manual that comes with the SCSI controller.
Setting the terminator
Set the terminator to "OFF".
IMPORTANT:
Installation
Follow the steps below to install the 5-inch device.
1.
See the section "Preparing for Installation and Removal" described earlier.
2.
Unlock the front bezel using the security key, and remove the front bezel.
3.
Remove the two screws, and remove the top cover from the server.
4.
Push the levers on both sides of the rear of the dummy tray to unlatch the tray, then pull out the dummy tray
toward the front.
To use a SCSI tape device, connect it to the optional SCSI controller.
9-14