Table of Contents
Advertisement
Installation, Relocation, Storage, and Connection
Never attempt to lift the server only by yourself.
Your server weighs 47 kg (depending on its hardware configuration). Carrying
the server only by yourself may strain your back. Hold the server firmly by its
bottom with at least three persons to carry it. Do not hold the front bezel to lift
the server. The front door may disengage from the server, causing personal
injury.
Do not install your server on a rack without its cover.
Failure to follow this instruction may reduce the cooling effect in the server,
resulting in some malfunction and/or dust entering the server, and resulting in a
fire or electric shock.
Do not pinch your finger with rails or other components.
Use a screwdriver or any other tool to press the safety latch release lever on
the rack slide rail. Pressing the levers with your finger may cause an injury.
Do not apply any load on the server when it is pulled out from the rack.
Doing so bends the frame of the server, and consequently, the server cannot
be pushed back into the rack. Placing an object on the server may also cause a
personal injury if the server should fall.
Do not install the server in any place other than the ones specified.
Do not install the server in the following places or any places other than the
ones specified in this manual. Failure to follow this instruction may cause a fire.
a dusty place
a humid place such as near a boiler
a place exposed to direct sunlight
an unstable place
Do not use the equipment in a place where corrosive gases exist.
Make sure not to locate or use the server in the place where corrosive gases
(sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone,
etc) exist.
Also, do not set it in the environment where the air (or dust) includes
components accelerating corrosion (ex. sulfur, sodium chloride) or conductive
metals. There is a risk of a fire due to the corrosion and shorts of an internal
printed board.
CAUTION
1-6
Advertisement
Table of Contents
