Top Cover
To install or remove the PCI board, or to change the internal cable connections, you will need to remove the top cover.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
¨Power off the server before removing the top cover.
Removal
1.
See the section "Preparing for Installation and Removal" described earlier.
2.
Remove the front bezel.
3.
Pull out the server from the rack.
4.
Loosen the two captive screws on the front panel.
5.
Slide the top cover toward the rear of the chassis.
6.
Lift the cover up and away from the chassis.
Captive screws
CAUTION
9-12