Configuring The Transmitter; Basic Configuration - Honeywell SLG 700 User Manual

7.7 Configuring the Transmitter

7.7.1

Basic Configuration

The DTM version offers two setup options: Guided and Unguided.
Note:
The local display and DD version do not offer a guided setup option.
Completion of the Basic Configuration is a quick way to start operating the SLG 700 transmitter in
most applications. This configuration consists of only few steps and the Guided Setup option
available from the Welcome page is provided to step the user through the various menu items in
this configuration category. After completing the Guided Setup process the Basic Configuration
menu can be revisited at any time by selecting Basic Configuration from the top three menu
buttons, as shown below in Figure
The Basic Configuration menu groups the most commonly modified parameters into five
categories; General, Process, Measurement, Dynamic Variables, and 4-20mA Outputs. The
parameters in these groups address the major site-specific configuration that might be needed
during the commissioning of a transmitter. When accessing the display for each of these groups
through the Basic Configuration menu there are a few additional parameters available that are not
present when accessing these displays through the Guided Setup mode.
Page 76
5.
Figure 5: Basic Configuration - General
SLG 700 Series HART Option User's Manual
Revision 5