Honeywell SLG 700 User Manual page 108

The Level Transmitter measures only distance and related quantities (level, percent of range, etc.).
The calculation of volume by the transmitter is based on measured level and additional tank
geometry measurements.
Figure 21: Advanced Configuration: Volume Calculation – Strapping Table
Wet Volume Calibration
When the measured level for the tank reaches a level where the corresponding volume is known,
select a row in the strapping table, enter the corresponding volume in the textbox below, and press
the arrow button. This will immediately set the values into the selected row in the strapping table
(i.e. immediately set in the transmitter).
Note:
Page 100
This feature is disabled when a user makes other changes on
this screen. Apply or discard any other changes before
configuring Wet Volume calculation
SLG 700 Series HART Option User's Manual
Revision 5