Honeywell SLG 700 User Manual page 37

Table 5 - Advanced Configuration parameters, cont'd
Key: Plain = Read only
Write
Protection
Image
Displays the current configuration of the write protect function. Write Protect is "Enabled" if
Write protect
either the write protect jumper on the electronics board is in the "ON" position or the
firmware write protect has been enabled.
The write protect jumper must be set in the Enabled position for SIL safety applications.
Write Protect
Configure the firmware write protect option.
On/Off
Write Protect selections are:
Enable: Enables the firmware write protect option (changes in configuration parameters
will not be permitted).
Disable: Disables the firmware write protect option (requires a password).
A 4-digit password is required to change the Write Protect option from "Enabled" to
"Disabled" to allow configuration changes. The default password is "0000", and can be re-
configured by the user.
Note: This cannot be changed if transmitter's Write Protect hardware jumper is disabled.
See the SLG 700 Transmitter User's Manual, Document #34-SL-25-11 for details.
Change Used to change the write protect password. Disable write protect option before changing
Password the password.
Disable: Disables the firmware write protect option (requires a password).
A 4-digit password is required to change the Write Protect option from "Enabled" to
"Disabled" to allow configuration changes. The default password is "0000", and can be re-
configured by the user.
Enter old password and then enter New password.
Apply values Applied re-range. Set 4mA and 20mA by current applied process values
D/A trim Defined in section 4.3.1
Loop test Used to perform the loop test.
Choose 4mA and 20mA analog output levels and fix the field device outputs at 4mA and
20mA
Revision 5
Bold = Configurable Bold underline = Method
Services cont.
SLG 700 Series HART Option User's Manual
Bold italic = Table or graph
Page 29