Slg 700 Online Parameterization; Dtm Help - Honeywell SLG 700 User Manual

9. Right click on the added device in the project menu and select Parameter from the
context menu.
10. In the HART Communication DTM's Parameter window, click on the Serial Interface pull-
down menu and select the correct port that the HART modem has been connected to,
then click on the OK button in the lower right-hand corner.
11. Right click on the HART Communication device in the project view and select Add Device
from the context menu. In the device pop-up window select the SLG700 HART device
that matches the transmitter model, SLG 700 HART Rev.1 R100, Rev.2 R101 and Rev.3
R102. Click on the OK button at the bottom of the window.
12. Right click on the SLG700 HART device in the project menu and select Connect from the
context menu. After a few seconds the device label should turn to bold.
13. Right click on the SLG700 HART device in the project window and select Parameter-
>Online Parameterization from the context menu. The SLG700 Welcome screen will be
displayed while the DTM is reading some basic configuration parameters from the
transmitter.
14. When the initial reading of data is completed the Welcome display will provide 3 options
to advance to the main menu items. If familiar with the device, select proceed to
Advanced SetupBrowse through the menus to access various parameters/functions.

7.5 SLG 700 Online Parameterization

The following sections provide a high level overview of SLG 700 DTM screens.
 Guided setup takes the user step by step through the Basic
 Advanced Setup goes to Advanced Configuration tab,
 Dashboard goes to the Monitor tab,

7.6 DTM Help

Mouse over the symbol next to a parameter to read its description. On some pages the user
can click on
Revision 5
page 112
if available.
SLG 700 Series HART Option User's Manual
Configuration, page 76.
page 90.
Page 75