Common Buttons - Cisco ASA 5505 Configuration Manual

Common Buttons

device; however, that device must run the same version of ASDM that you are currently running. To
display the pane fully, you must have at least two devices listed. This feature is available in routed and
transparent modes, and in the single, multiple, and system contexts.
To use this pane to connect to another device, perform the following steps:
Click Add to add another device to the list.
Step 1
The Add Device dialog box appears.
In the Device/IP Address/Name field, type the device name or IP address of the device, and then click
Step 2
OK.
Click Delete to remove a selected device from the list.
Step 3
Click Connect to connect to another device.
Step 4
The Enter Network Password dialog box appears.
Type your username and password in the applicable fields, and then click Login.
Step 5

Common Buttons

Many ASDM panes include buttons that are listed in the following table. Click the applicable button to
complete the desired task:
Button
Apply
Save
Reset
Restore Default
Cancel
Enable
Close
Clear
Back
Forward
Help
Cisco ASA 5500 Series Configuration Guide using ASDM
3-12
Description
Sends changes made in ASDM to the adaptive security appliance and applies
them to the running configuration.
Writes a copy of the running configuration to flash memory.
Discards changes and reverts to the information displayed before changes
were made or the last time that you clicked Refresh or Apply. After you click
Reset, click Refresh to make sure that information from the current running
configuration appears.
Clears the selected settings and returns to the default settings.
Discards changes and returns to the previous pane.
Displays read-only statistics for a feature.
Closes an open dialog box.
Remove information from a field, or remove a check from a check box.
Returns to the previous pane.
Goes to the next pane.
Displays help for the selected pane or dialog box.
Chapter 3 Using the ASDM User Interface
OL-20339-01