Cisco ASA 5505 Configuration Manual page 467

Chapter 24 Configuring Multicast Routing
Choose the interface for which you are configuring the multicast boundary filter ACL from the Interface
Step 3
drop-down list.
Step 4 Check the Remove any Auto-RP group range check box to filter Auto-RP messages from sources
denied by the boundary ACL. If unchecked, all Auto-RP messages are passed.
Step 5 Click OK.
Configuration Example for Multicast Routing
The following example shows how to enable and configure multicast routing with various optional
processes:
In the main ASDM window, choose Configuration > Device Setup > Routing > Multicast.
Step 1
In the Multicast pane, check the Enable Multicast routing check box, and click Apply.
Step 2
In the main ASDM window, choose Configuration > Device Setup > Routing > Multicast > MRoute.
Step 3
Choose Add or Edit.
Step 4
The Add or Edit Multicast Route dialog box appears.
Use the Add Multicast Route dialog box to add a new static multicast route to the adaptive security
appliance. Use the Edit Multicast Route dialog box to change an existing static multicast route.
In the Source Address field, enter the IP address of the multicast source. You cannot change this value
Step 5
when editing an exiting static multicast route.
Choose the network mask for the IP address of the multicast source from the from the Source Mask
Step 6
drop-down list.
In the Incoming Interface area, click either the RPF Interface radio button to choose RPF to forward
Step 7
the route, or click the Interface Name radio button and enter the following:
•
•
Note
In the Administrative Distance field, choose the administrative distance of the static multicast route. If
Step 8
the static multicast route has the same administrative distance as the unicast route, then the static
multicast route takes precedence.
Step 9 Click OK.
In the main ASDM window, choose Configuration > Device Setup > Routing > Multicast > IGMP >
Step 10
Join Group.
The Join Group pane appears.
Choose Add or Edit.
Step 11
The Add IGMP Join Group dialog box allows you to configure an interface to be a member of a multicast
group. The Edit IGMP Join Group dialog box to change existing membership information.
OL-20339-01
In the Source Interface field, choose the incoming interface for the multicast route from the
drop-down list.
In the Destination Interface field, choose the destination interface that the route is forwarded
through the selected interface form the drop-down list.
You can specify the interface, or the RPF neighbor, but not both at the same time
Configuration Example for Multicast Routing
Cisco ASA 5500 Series Configuration Guide using ASDM
24-17