Cisco ASA 5505 Configuration Manual page 381

Chapter 20 Defining Route Maps
Configuration Example for Route Maps
The following example shows how to redistribute routes with a hop count equal to 1 into OSPF.
Step 1 In ASDM, choose Configuration > Device Setup > Routing > Route Maps.
Step 2 Click Add.
Step 3 Enter 1-to-2 in the Route Map Name field.
Enter the routing sequence number in the Sequence Number field.
Step 4
Click the Permit radio button
Step 5
By default this tab is on top.
Click the Match Clause tab.
Step 6
Check the Match Metric of Route check box and type a value of 1 for the metric
Step 7
Click the Set Clause tab.
Step 8
Check the Set Metric Value check box, and type a value of 5 for the metric value.
Step 9
Check the Set Metric-Type check box, and choose Type-1.
Step 10
Feature History for Route Maps
Table 20-1
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 20-1 Feature History for Static and Default Routes
Feature Name
Route mapping
Enhanced support for static and dynamic route
maps.
OL-20339-01
lists each feature change and the platform release in which it was implemented. ASDM is
Platform
Releases
7.0(1)
8.0(2)
Feature Information
The route-map command allows you to define a route map
entry.
The Configuration > Device Setup > Routing > Route
Maps screen was introduced.
Enhanced support for dynamic and static route maps was
added.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuration Example for Route Maps
value.
20-7