Cisco ASA 5505 Configuration Manual page 410

Configuring RIP
Enabling RIP
You can only enable one RIP routing process on the adaptive security appliance. After you enable the
RIP routing process, you must define the interfaces that will participate in that routing process using the
network command. By default, the adaptive security appliance sends RIP Version 1 updates and accepts
RIP Version 1 and Version 2 updates.
In ASDM, to enable a RIP process, perform the following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 1
The main RIP Setup pane appears.
From this pane you can perform the following tasks:
•
•
•
•
•
Step 2 Check the Enable RIP routing check box.
After the Enable RIP routing box has been checked, you can enable RIP on the adaptive security
appliance and configure global RIP protocol parameters. You can only enable a single RIP process on
the adaptive security appliance. When you enable RIP, it is enabled on all interfaces. Checking this check
box also enables the other fields in this pane. Uncheck this check box to disable RIP routing on the
adaptive security appliance.
Click Apply.
Step 3
To customize the RIP process, see the
Cisco ASA 5500 Series Configuration Guide using ASDM
22-4
Enable Auto-summarization—See the
Enable RIP version—See the
Enable default information origination.
Define an IP Address for a Network to Add—See the
page 22-9.
Configure an Interface—See the
"Configuring Route Summarization" section on page
"Configure the RIP Version" section on page
"Filtering Networks in RIP" section on
"Configuring Interfaces for RIP" section on page
"Configuring RIP" section on page
Chapter 22 Configuring RIP
22-8.
22-5.
22-6.
22-3.
OL-20339-01