Cisco ASA 5505 Configuration Manual page 531

Chapter 27 Configuring Network Object NAT
Figure 27-11
In the Translated Addr field, specify the mapped IP address.
Step 6
Note
Do one of the following:
Type a host IP address.
•
Type an interface name or click the browse button
•
Translated Addr dialog box.
Figure 27-12
If you specify an interface name, then you enable interface PAT, where the specified interface IP
address is used as the mapped address. With interface PAT, the NAT rule only applies to the specified
mapped interface. (If you do not use interface PAT, then the rule applies to all interfaces by default.)
See
Note
Click the browse button
•
dialog box. You can also create a new named object from the Browse Translated Addr dialog box
and use this object as the mapped address.
OL-20339-01
Configuring Dynamic PAT
You can share this mapped IP address across different dynamic PAT rules, if desired.
Browse Dialog Box
Step 8 to optionally also configure the real interface to be a specific interface instead of --Any--.
You cannot specify an interface in transparent mode.
, and choose an existing host address from the Browse Translated Addr
, and choose an interface from the Browse
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuring Network Object NAT
27-9