Configuring Network Object NAT
Figure 27-13
See the
addresses.
(Optional) Click Advanced, and configure the following options in the Advanced NAT Settings dialog
Step 7
box. When you are finished, click OK.
Figure 27-14
To translate the IP address in DNS replies, check the Translate DNS replies for rule check box.
•
Be sure DNS inspection is enabled (it is enabled by default). See the
page 26-21
To specify the real and/or mapped interfaces where this NAT rule should apply, under Interface,
•
choose the source and destination interfaces.
By default, the rule applies to all interfaces.
You return to the Add/Edit Network Object dialog box.
Click OK, and then Apply.
Step 8
Cisco ASA 5500 Series Configuration Guide using ASDM
27-10
Browse Dialog Box
"Guidelines and Limitations" section on page 27-2
Configuring Advanced NAT Settings
for more information.
Chapter 27
Configuring Network Object NAT
for information about disallowed mapped IP
"DNS and NAT" section on
OL-20339-01