Cisco ASA 5505 Configuration Manual page 348

Default Settings
Context Mode Guidelines
Supported in single context mode only.
Firewall Mode Guidelines
Supported in routed and transparent firewall modes.
IPv6 Guidelines
Supports IPv6.
Additional Guidelines and Limitations
The following guidelines and limitations apply for standard ACLs:
•
•
•
Default Settings
Table 17-1
Table 17-1
Parameters
deny
Adding Standard ACLs
This section includes the following topics:
•
•
•
•
Cisco ASA 5500 Series Configuration Guide using ASDM
17-2
Standard ACLs identify the destination IP addresses (not source addresses) of OSPF routes and can
be used in a route map for OSPF redistribution. Standard ACLs cannot be applied to interfaces to
control traffic.
When specifying a source, local, or destination address, use the following guidelines:
Use a 32-bit quantity in four-part, dotted-decimal format.
–
lists the default settings for standard ACL parameters.
Default Standard Access List Parameters
•, page 17-2
Using Standard ACLs, page 17-3
, page 17-4
Chapter 17
Default
The adaptive security appliance denies all packets
on the originating interface unless you specifically
permit access.
Access list logging generates system log message
106023 for denied packets. Deny packets must be
present to log denied packets.
Adding a StandardACL
OL-20339-01