Cisco ASA 5505 Configuration Manual page 249

Chapter 8 Configuring Interfaces
Click OK.
Step 11
What to Do Next
To complete the interface configuration, see the
section on page
Completing Interface Configuration (All Models)
This section includes tasks to complete the interface configuration for all models.
Note For multiple context mode, complete the tasks in this section in the context execution space. In the
Configuration > Device List pane, double-click the context name under the active device IP address.
This section includes the following topics:
•
•
•
•
Task Flow for Completing Interface Configuration
Complete the procedures in the
Step 1
page 8-9
Step 2 (Multiple context mode) In the Configuration > Device List pane, double-click the context name under
the active device IP address.
Step 3 Configure general interface parameters, including the interface name, security level, and IPv4 address.
See the
For transparent mode, you do not configure IP addressing per interface, except for the management-only
interface (see the
configure the other parameters in this section, however. To set the global management address for
transparent mode, see the
(Optional) Configure the MAC address and the MTU. See the
Step 4
Parameters" section on page
(Optional) Configure IPv6 addressing. See the
Step 5
For transparent mode, you do not configure IP addressing per interface, except for the management-only
interface (see the
includes how to set the link-local address in transparent mode, but this task is usually not required. To
set the global management address for transparent mode, see the
on page
OL-20339-01
8-21.
Configuring General Interface Parameters, page 8-22
Configuring Advanced Interface Parameters, page 8-26
Configuring IPv6 Addressing, page 8-27
Configuring the Link-Local Address on an Interface (Transparent Firewall Mode), page 8-30
or the "Starting Interface Configuration (ASA 5505)" section on page
"Configuring General Interface Parameters" section on page
"Information About the Management Interface" section on page
"Configuring the IPv4 Address" section on page
8-26.
"Information About the Management Interface" section on page
9-16.
"Completing Interface Configuration (All Models)"
"Starting Interface Configuration (ASA 5510 and Higher)" section on
"Configuring IPv6 Addressing" section on page
Cisco ASA 5500 Series Configuration Guide using ASDM
Completing Interface Configuration (All Models)
8-16.
8-22.
8-22). You do need to
9-15.
"Configuring Advanced Interface
8-22). This section
"Configuring the IPv6 Address" section
8-27.
8-21