Rear Panel Leds And Buttons - Cisco 380 Series Hardware Installation Manual

Rear Panel LEDs and Buttons

Figure 1-8
Figure 1-8
1
1
2
3
4
Table 1-2 Rear Panel LEDs, Definitions of States
LED Name
Power supply fault
Power supply AC OK
1-Gb Ethernet dedicated
management link speed
1-Gb Ethernet dedicated
management link status
Cisco 380 and Cisco 680 Series Hardware Installation Guide
1-10
shows the rear panel LEDs and buttons.
Rear Panel LEDs and Buttons
PSU1
2
Power supply fault LED
Power supply AC OK LED
1-Gb Ethernet dedicated console link status
LED
1-Gb Ethernet dedicated console link speed
LED
State
Off—The power supply is operating normally.
•
Amber, blinking—An event warning threshold has been reached, but the power
•
supply continues to operate.
Amber, solid—A critical fault threshold has been reached, causing the power
•
supply to shut down (for example, a fan failure or an over-temperature condition).
Off—There is no AC power to the power supply.
•
Green, blinking—AC power OK, DC output not enabled.
•
Green, solid—AC power OK, DC outputs OK.
•
Off—link speed is 10 Mbps.
•
Amber—link speed is 100 Mbps.
•
Green—link speed is 1 Gbps.
•
Off—No link is present.
•
Green—Link is active.
•
Green, blinking—Traffic is present on the active link.
•
Table 1-2
PCIe 5
PCIe 4
PSU2
1-Gb Ethernet link speed LED
5
1-Gb Ethernet link status LED
6
Identification button/LED (For more
7
information, see
section on page
–
defines the LED states.
PCIe 1
PCIe 2
PCIe 3
3 4 5 6
"Replacing Hard Drives"
3-3.)
Chapter
7
OL-29172-01