Configuration Examples for Twice NAT
By default, the NAT rule is added to the end of section 1. If you want to add a NAT rule to section 3,
after the network object NAT rules, choose Add NAT Rule After Network Object NAT Rules.
The Add NAT Rule dialog box appears.
Figure 28-31
Set the source and destination interfaces:
Step 2
Figure 28-32
For the Original Source Address, click the browse button
Step 3
network in the Browse Original Source Address dialog box.
a.
Add the new network object.
Figure 28-33
Define the inside network addresses, and click OK.
b.
Cisco ASA 5500 Series Configuration Guide using ASDM
28-20
Add NAT Rule Dialog Box
Setting the Interfaces
Adding a New Network Object for the Inside Network
Chapter 28
Configuring Twice NAT
to add a new network object for the inside
OL-20339-01