External Connectors; Serial Connector (Com1 And Com2) - Honeywell Thor vm3 User Manual

External Connectors

Power the Thor VM3 off before attaching a cable to any port (serial, USB, Audio/CAN, etc.).
The external I/O connectors for the Thor VM3 are located on the right side of the Quick Mount Smart Dock (when viewed from
the back).
The Power Supply Connector
Antenna connectors are located on the top rear of the Thor VM3.

Serial Connector (COM1 and COM2)

COM1
COM2
USB
CANBUS/AUDIO
Standard Dock
Screen Blanking
The screen blanking signal can be provided either by a Honeywell Screen Blanking Box or a user supplied switch or
relay. See Screen Blanking
(page 3-7) is on the left side of the dock (when viewed from the back).
Enhanced Dock
(page 4-32) for information on connecting screen blanking accessories.
The COM1 and COM2 connectors are D-9 male con-
nectors located on the back of the Quick Mount Smart
Dock.
Power the Thor VM3 off before attaching a cable to
any port (serial, USB, Audio/CAN, etc.).
The serial connectors are industry-standard RS-232,
PC/AT standard 9–pin "D" male connector. See
COM1 and COM2 Connector
pinout detail.
See Connect Serial Device
mation.
If a COM port is not being used for a scanner, it can
be used for Screen Blanking
vehicle is in motion.
(page 9-6) for connector
(page 4-41) for more infor-
(page 4-32) when the
3 - 5