Honeywell Thor vm3 User Manual page 63

5. Route the power cable the shortest way possible removing any left-over cable. The cable is rated for a maxi-
mum temperature of 105°C (221°F). Therefore, when routing this cable it should be protected from physical
damage and from surfaces that might exceed this temperature. Cable should be protected from physical
damage from moving parts. Do not expose the cable to chemicals or oil that may cause the wiring insulation
to deteriorate. Always route the cable so that it does not interfere with safe operation and maintenance of the
vehicle.
6. Provide mechanical support for the cable by securing it to the vehicle structure at approximately one foot inter-
vals, taking care not to over tighten and pinch conductors or penetrate outer cable jacket.
7. Connect the watertight connector end of the power cable to the Thor VM3 Smart Dock power connector by
aligning the connector pins to the power connector; push down on the watertight connector and twist it to fas-
ten securely.
8. Secure the power cable to the Thor VM3 using the
9. Place Thor VM3 in the Dock
10. If using the Screen Blanking
11. Press the Power Switch
12. Press the Power Button
(page 4-2)
(page 4-32) feature, install the screen blanking box or switch.
(page 3-4) on the back of the Thor VM3 dock.
(page 3-4) on the front of the Thor VM3 to turn on the Thor VM3.
Strain Relief Cable Clamps (page 4-16).
4 - 19