Error Reporting - Honeywell Thor vm3 User Manual

Select the appropriate scanner model (SR Intermec Scanner, ASCII, SR60). By default, both COM1 and COM2
are opened so the appropriate scanners (see below) can work without changing factory defaults:
Tethered Scanner (COM1)
By default the Scanner Model is set to SR Intermec Scanner, which covers models such as SR61T, SR30,
and SR31.
Tethered Scanner (COM2)
By default the Scanner Model is set to ASCII to connect with a scanner with baud rate of 9600, 8 data bits, no
parity, 1 stopbit, and no flow control.
Bluetooth Scanners
See Bluetooth Scanning
Always use Enterprise Settings to configure Bluetooth parameters. Do not use the Bluetooth configuration options
available from the Bluetooth icon in the system tray.
USB Scanners
When a HID enabled USB scanner is connected to the Thor VM3 the scanned data is transmitted to the active win-
dows as keystroke messages. Any data handling to be applied to the scanned data (for example to strip leading or
trailing characters) must be programmed into the scan engine. This is done by scanning configuration bar codes from
the scanner manufacturer or handled by the application accepting the data. Note that Enterprise Settings data collec-
tion does not support USB Scanners.

Error Reporting

Start > Settings > Control Panel > Error Reporting
By default, error reporting is enabled (requires Internet connection).
5 - 30
(page 5-20) for information on connecting Bluetooth scanners.