Honeywell Thor vm3 User Manual page 218

To configure a WWAN network, tap the View Network Settings button. To configure the WLAN connection use the
Wireless Configuration Utility (WCU)
Connection Type
Use this tab to configure the connection parameters. The tab is identified by the type of connection, i.e.: UMTS, LTE,
UDMA, etc. The label on this tab corresponds to the Technology field on the
Note that the SIM card being configured (Sim1 or Sim2) is identified at the top of this tab.
If the WWAN radio fails to connect, please check that the correct APN is entered. This entry can be verified by
contacting the WWAN carrier.
An APN mismatch may generate an error message, however this is not always the case. The first step in diag-
nosing a connection error should be to verify the APN.
After all entries are completed, tap the Save button.
7 - 44
(page 7-1).
About (page 7-50) tab.
WLAN