Fuse; Power Management Modes; Power Controls - Honeywell Thor vm3 User Manual

Fuse

Standard Dock

Power Management Modes

Power Controls

Power Switch
Standard Dock
Power Button
3 - 4
The Thor VM3 uses an 8A time delay (slow blow) fuse that is externally
accessible and user replaceable. The fuse is located on the back of the
dock. The fuse is accessed by unscrewing the cap as indicated.
Should it need replacement, replace with same size, rating and type of
fuse:
• Littelfuse 0215008.MXP
• Cooper Bussmann BK1/S506-8-R
• Bel Fuse 5HT 8-R
or equivalent.
Fuse has voltage on it even when power is off. Always disconnect input
power before changing the fuse.
Enhanced Dock
Enhanced Dock
The power button is located at the lower left of the Thor VM3.
If the Thor VM3 is Off, pressing the power button starts the power up
sequence.
Note: This assumes that the Thor VM3 is docked in a powered
If the Thor VM3 is On, pressing the power button places the unit in
Suspend.
After all cables are connected, the Thor VM3 can be powered on.
There is a power switch located on the back of the dock. The power
switch is a rocker switch.
The power switch has a raised bump to identify the switch position
even when it is hidden from view. When the side of the switch with
the raised bump is pressed, the power switch is On. If the dock is
connected to external power, the dock delivers power to the Thor
VM3.
Generally, once the dock is powered On, there is no need to power
it off. The dock power can remain On even when the Thor VM3 is
not attached.
Quick Mount Smart Dock or that the internal UPS battery has
a sufficient charge to power the Thor VM3. If no external
power is available and the UPS battery does not have a
charge, pressing the power button causes no action.