Password - Honeywell Thor vm3 User Manual

Password

Start > Settings > Control Panel > Password
Important: This password must be entered before performing a Load Factory Defaults.
If entering a power-on or screen saver password does not allow you to disable this password protection or perform a Load
Factory Defaults, contact
Factory Default Settings
Prompt if device unused for
Timeout
Password
Password
• The password and password settings are saved during a restart.
• After a password is assigned and saved, each time a Settings > Control Panel option is selected, the user will be
required to enter the password before the Control Panel will open.
Check the box to enable the password, enter a timeout and select a password type.
Enter the password in the Password text box, then press Tab and type the password again to confirm it.
A changed/saved password is in effect immediately.
Hint
Use this screen to enter a hint in case the password is forgotten.
5 - 46
Technical Assistance (page 10-1).
Disabled
0 minutes
Blank