Honeywell Thor vm3 User Manual page 162

4. Tap OK to confirm changes or Cancel to discard changes.
Set Zoom Area
The ZoomArea can be selected from the current active desktop display. To set the zoom area:
1. Display the desired content on the Thor VM3 desktop.
2. Open the ZoomZone interface.
3. Tap the Set Zoom Area button.
4. Select the desired zoom area by tapping on the upper left corner of the desired area and dragging to the lower
right corner of the desired area. The selected area is highlighted by a red outline.
Note: Be sure to select the desired area from the upper left corner to the lower right. Selecting the area from a
different corner may result in nothing (a black box) being displayed.
5. If the selected are is not satisfactory, repeat the step above to reselect an area.
6. At the top of the display, tap File and select one of the available options:
• Save - Saves the selected zoom area are returns to the ZoomZone user interface.
• Test - Previews the zoom area as it would be displayed during screen blanking.
» Tap Accept Zoom to keep the zoom area and finish, or
» Tap Reject Zoom to discard the zoom are and be returned to select a different zoom area.
• Exit - Discards changes and returns to the ZoomZone user interface.
Show Zoom Area
Tap the Show Zoom Area button to show the currently selected zoom area. The selected area is highlighted in red.
To see how the zoom area would be displayed during screen blanking.
When finished, at the top of the display tap File > Exit to exit.
Test Zoom Area
Tap the Test Zoom Area button.
The zoom image is displayed.
When finished, at the top of the display tap File > Exit to exit.
5 - 64