Maintenance - Vehicle Mounted Devices; Cleaning; Place Thor Vm3 In The Dock - Honeywell Thor vm3 User Manual

Maintenance - Vehicle Mounted Devices

Check the vehicle mounting hardware frequently and re-tighten if necessary.
If the vehicle mounting hardware and connections become broken, loose or cracked, the assembly must be taken out of service
and replaced. Contact Technical Assistance

Cleaning

If it becomes necessary to clean the Thor VM3, dock, peripherals or mounting hardware see:
• Cleaning the Thor VM3 and the Dock
• Cleaning the Touch Screen

Place Thor VM3 in the Dock

Back of Thor VM3
1. Locate the notch on the upper rear of the Thor VM3.
2. Slide this notch over the top lip of the dock. Slide the Thor VM3 from side to side on the dock to make sure it fully engages
on the lip of the dock. If the Thor VM3 cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever on the Thor VM3 down and push the Thor VM3 against the dock.
4. Release the quick release lever. The quick release lever catches the lower lip on the dock and secures the Thor VM3 to the
dock. Be sure the red quick release lever is pushed all the way in to secure the Thor VM3 to the dock.
5. If necessary, adjust the viewing angle of the Thor VM3.
When the Thor VM3 is placed in the dock, the following may happen:
When the Thor VM3 is removed from the dock, the following may happen:
4 - 2
(page 10-1) for help.
(page 2-11)
(page 2-11)
Release Lever
Front of Dock
Notch on
Lower Lip on Dock
Thor VM3
Upper Lip on Dock