Honeywell Thor vm3 User Manual page 80

DC/DC Power Supply with Screws on Top of Lid
Inspect the cable shield to verify it is connected to chassis ground. If there is no connection from the cable
shield to chassis ground, one must be added at this time. Use a jumper wire to connect the cable shield to
chassis ground as shown below for the appropriate type of power supply installed on the vehicle. A jumper
wire, as shown in the illustrations below, may be present to attach the chassis ground to the white wire of the
power cable. This wire is not necessary but can be left in place if present. For proper screen blanking, verify
the yellow and green wires are attached to the screen blanking box as shown in the illustrations below.
For this model, follow the diagram below to attach the power cable shield to chassis ground:
Existing Circuitry on Vehicle
Main Switch
10A slow fuse
Close to power
source
DC/DC
Power
Supply
For battery powered vehicles:
+ is connected to battery positive.
- must be connected to battery negative.
must be connected to the vehicle chassis ground.
For internal combustion engine powered vehicles:
+ is connected to battery positive.
- is connected to battery negative.
is connected to the vehicle chassis ground, which can also be battery negative.
4 - 36
Forklift Battery
MOTION
CIRCUITRY
+Vo -Vo
3A fuse
+ -
+
-
Supplied Power Cable
(Shielding to be trimmed)
VMX004VMCRADLE
Vehicle Mount
Smart Dock
5
Green
6
Circular
Yellow
Power
Connector
1
Brown
3
White