Link Settings - Honeywell Thor vm3 User Manual

Link Settings

The available network connections are shown on this tab:
The WLAN network can be enabled or disabled from this tab, however configuration settings for the 802.11 a/b/g/n radio
are set with the WLAN Wireless Configuration Utility (WCU)
The WWAN networks, if any, are shown on this page. A WWAN network is only displayed if a SIM card has been installed
for that network. The Thor VM3 supports two SIM cards. See
instructions. A WWAN network can be enabled or disabled from this screen, however the connection is configured by tap-
ping the applicable Network Settings button.
To change the order (Priority) of the networks:
1. Select the desired network. When selected, the network has a green check mark to the left.
2. Tap the Up or Down button to move the network in the desired direction.
3. Tap the Save button after the order is set.
To change the other options (Enable, Threshold, Dwell, Connect Attempts):
1. To enable or disable a carrier, tap the checkbox to the left of the carrier name. When checked, the carrier is enabled.
2. For other parameters, double tap the cell containing the value that is to be changed. The value in the cell can now be
edited.
3. Enter the desired value.
4. Tap anywhere else on the screen to exit the editing mode.
5. The values that can be changed are:
• Threshold - The signal strength (in dBm) before roaming can occur to this connection. The default is -93 dBm.
• Dwell - The length of time (in seconds) to wait before attempting the connection. The default is 10 seconds.
• Connect Attempts - The number of times this connection is tried. If there is no successful connection after this many
tries, the next connection is tried.
(page 7-1).
Install SIM Card(s) (page 4-51) for SIM card installation
7 - 43