Honeywell Thor vm3 User Manual page 96

6. Locate the SIM card holders. The
top slot (the slot closest to the top of the Thor VM3 as slot 1 (SIM 1) and the lower slot as slot 2
(SIM 2).
Note: If an mSATA drive has been installed, it is necessary to remove the drive before installing
the SIM card(s).
7. Slide the silver retainer clip toward the center of the Thor VM3.
8. After the clip is slid in, lift the outer edge of the SIM holder so it is at a 45º to 90º angle (compared
to the circuit board on which it is mounted).
9. Insert the SIM card into the SIM holder.
Note: The SIM card does not have a "spring lock" type holder. Slide the SIM card into the holder
but do not push it expecting it to lock into place. The SIM card will be held in place when
the card holder is closed.
10. Lower the SIM holder to back to its flat position.
11. Slide the silver retainer clip back toward the outside edge of the Thor VM3. This locks the SIM
card in place.
12. Reattach the access panel, torquing the screws to 7.0 ± 0.5 inch pounds.
13. Reinstall the Thor VM3 in the dock.
14. Resume the Thor VM3 from Suspend.
15. Restart the Thor VM3 (Start | Settings | Control Panel | Registry and tap the Restart button).
4 - 52
VM3 WWAN Connection Manager
SIM
(page 6-40) identifies the