Mipclose, Close A Socket - Motorola G24 Guide Developer's Manual

GPRS/EDGE
Listen socket over TCP:
AT+MIPODM=1,1100,"0.0.0.0",0,0// Listens to any port at any IP.
OK
+MIPODM: 1,1,122.221.32.64,1200// Remote side connected to the listen socket.
AT+MIPODM=3,3212,"122.1.222.134",0,0 // Listen to any port at specific IP.
OK
+MIPODM: 3,1,122.1.222.134,1222// Remote side connected to the listen socket.
//SSL
AT+MIPODM=2,2222,"www.google.com",443,2// TCP secured with SSL.
OK
+MIPODM: 2,2// SSL connection opened.
AT+MIPODM=3,1234,"www.xyz.com",443,2// TCP secured with SSL.
OK
+MIPSSL: 3,15// SSL_UNKNOWN_CA alert.
+MIPODM: 3,2

+MIPCLOSE, Close a Socket

This command causes the G24 to free the socket accumulating buffer and to close the socket.
Note:
Command
Type
Set
Read
Test
3-392
All data stored in the accumulating buffer will be lost. Refer to
Timeout for Automatic Push" on page 3-394
Stack" on page 3-397.
Syntax
+MIPCLOSE = <Socket ID>
+MIPCLOSE?
+MIPCLOSE=?
AT Commands Reference Manual
"+MIPSETS, Set Size and
and "+MIPPUSH, Push Data into Protocol
Response/Action
OK
+MIPCLOSE: <Socket ID>[,<
number_of_acknowledged_bytes >],<close_type>
or:
ERROR
+MIPCLOSE: [<socket ID>]
OK
(for all ACTIVE
sockets)
OR:
+MIPCLOSE: 0
OK
(if no active sockets)
+MIPCLOSE: (1-4)
OK
December 31, 2007