Mvc, Motorola Vocoders Configuration - Motorola G24 Guide Developer's Manual

+MVC, Motorola Vocoders Configuration

This AT command is used to choose and configure the priority order of the supported voice
codecs (vocoders).
The phone will restart 10 seconds after the set command execution completed. Changes take
effect after restart.
Command
Type
Set
Read
Test
The following table shows the +MVC parameters.
<Parameter>
<n>
<p1>,<p2>,<p3>
,<p4>,<p5>
Example
AT+MVC=0
OK
AT+MVC=1,1,3,5
OK
// Delay 10 sec. Restart.
AT+MVC?
+MVC: 1,2,3
OK
AT+MVC=?
+MVC: (0-1),(1-5), (1-5), (1-5), (1-5), (1-5)
OK
December 31, 2007
Syntax
AT+MVC=<n>[,<p1>[,< OK
p2>[,<p3>[,<p4>[,<p5>]
or:
]]]]
+CME ERROR: <err>
AT+MVC? +MVC:
<p1>[,<p2>[,<p3>[,<p4>
[,<p5>]]]]
OK
or:
+CME ERROR: <err>
AT+MVC=? +MVC:
(0-1),(1-5) ,(1-5) ,(1-5)
,(1-5) ,(1-5)
OK
Table 3-19: +MVC Parameters
0 Restore default vocoder configuration.
1 Set vocoders and their priority order.
1 GSM full rate speech version 1.
2 GSM half rate speech version 1.
3 GSM full rate speech version 2 (EFR).
4 GSM full rate speech version 3 (AMR Full Rate).
5 GSM half rate speech version 3 (AMR Half Rate).
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
The command will save new vocoders
configuration or restore the default
configuration, wait 10 sec and restart
the phone.
The command will read the current
vocoders values.
The command shall return the list of
supported
<n>,<p1>,<p2>,<p3>,<p4>,<p5>
values.
Description
Remarks
3-43