Email
+MEMR, Read Email Message
This AT command is used to display an email message chosen by its <message_id>. <status> of
each message is changed to read status after the message is read for the first time.
Command
Type
Set
The following table shows the +MEMR parameters.
<Parameter>
<message_id>
<status>
<from>
<to>
<cc>
3-162
Syntax
AT+MEMR=<message_id>
Table 3-97: +MEMR Parameters
The identity number of the current message.
Status of the message (can be a combination of statuses).
<status>
Description
(decimal)
0
READ
1
SENT
2
UN-(read/sent)
4
Reserved
8
Reserved
16
Reserved
32
Reserved
64
Reserved
128
Reserved
Example:
0 = READ
1 = SENT
2 = UN-READ
3 = UN-SENT
Original message address.
Addresses of intended recipients of current email message. The maximum length of
this parameter is 500 characters.
Addresses of intended copy recipients of current email message. The maximum
length of this parameter is 500 characters.
AT Commands Reference Manual
Response/Action
+MEMR:<status>,<priorit
y><from>,<to>,<cc>,<bcc
>,<subject>,<date>,<body
>,<name_of_attachments>
OK
or:
+CME ERROR: <err>
Description
Remarks
December 31, 2007