Ats97, Antenna Diagnostic - Motorola G24 Guide Developer's Manual

Hardware Information
The following table shows the +ICF parameters.
<Parameter>
<format>
<parity>
Example
AT+ICF?
+ICF: 3,4
OK
AT+ICF=?
+ICF: (1-8),(0,1,4)
OK
AT+ICF=5,1
OK

ATS97, Antenna Diagnostic

This command indicates whether an antenna is physically connected to the G24 RF connector.
This information is also provided by a dedicated hardware signal, which is outputted on pin 41
(ANT_DET) of the interface connector.
Command Type
Execute
Read
3-206
Table 3-134: +ICF Parameters
Determines the number of bits in the data bits, the presence (or absence) of a parity
bit, and the number of stop bits in the start/stop frame.
1 8 Data, 2 Stop - can be set only with <parity> 4
2 8 Data, 1 Parity, 1 Stop - can be set with <parity> of 0 or 1
3 8 Data, 1 Stop (default) - can be set only with <parity> 4
4 7 Data, 2 Stop - can be set only with <parity> 4
5 7 Data, 1 Parity, 1 Stop - can be set with <parity> of 0 or 1
6 7 Data, 1 Stop - can be set only with <parity> 4
7 8 Data, 1 Parity, 2 Stop - can be set with <parity> of 0 or 1
8 7 Data, 1 Parity, 2 Stop - can be set with <parity> of 0 or 1
Determines how the parity bit is generated and checked (if present).
0 Odd
1 Even
4 No parity (default)
Syntax Response/Action
ATS97 OK
or:
+CME ERROR: <err>
ATS97? <info>
OK
or:
+CME ERROR: <err>
AT Commands Reference Manual
Description
Remarks
The Read command indicates whether
the antenna is connected.
December 31, 2007