Mscts, Enable/Disable Cts During Wakeup Period - Motorola G24 Guide Developer's Manual

Modem Configuration and Profile
<Parameter>
<delta>
Example
ats100?
001
OK
ats100=0
OK
ats100?
000
OK

+MSCTS, Enable/Disable CTS During Wakeup Period

This command defines the behavior of the CTS line when the G24 is in normal mode (not Sleep
mode).
The command configures the G24 CTS line behavior always to follow the flow control
requirements, or to follow it only if the terminal initiated a serial transmission session. This saves
the terminal from following the CTS interrupt every time the G24 exits Sleep mode for internal
G24 reasons (non-terminal communication related reasons).
Command
Type
Set
Read
Test
3-288
Table 3-191: Command parameters
Description
Time interval between one burst of sent/received
data to the other before the terminal enters sleep
mode.
0 : Wakeup out feature isn't active. (default when
+S100 set command is never used)
1 - 255: Time in seconds.
Syntax Response/Action
AT+MSCTS=<control> OK
AT+MSCTS? +MSCTS: <current
control>
OK
AT+MSCTS=? +MSCTS: (list of
supported <control>)
OK
AT Commands Reference Manual
Remarks
This value is saved on power
down.
Remarks
The Set command tells the G24
whether to activate the CTS when the
unit is awakening.
The Read command returns the current
control value.
The Test command returns the possible
control values.
December 31, 2007