Cgeqmin, (Minimum Acceptable) - Motorola G24 Guide Developer's Manual

GPRS/EDGE

+CGEQMIN, (Minimum acceptable)

This command allows the TE to specify a minimum acceptable profile, which is checked by the
MT against the negotiated profile returned in the Activate/Modify PDP Context Accept message.
Command
Type
Set
3-346
Syntax
+CGEQMIN=[<cid> OK
[,<Traffic class>
or:
[,<Maximum bitrate
ERROR
UL> [,<Maximum
bitrate DL>
[,<Guaranteed bitrate
UL> [,<Guaranteed
bitrate DL>
[,<Delivery order>
[,<Maximum SDU
size> [,<SDU error
ratio> [,<Residual bit
error ratio>
[,<Delivery of
erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling
priority>]]]]]]]]]]]]]
AT Commands Reference Manual
Response/Action Remarks
The set command
specifies a profile for the
context identified by the
(local) context
identification parameter,
<cid>. The specified
profile will be stored in
the MT and checked
against the negotiated
profile only at activation
or MS-initiated
modification of the
related context. Since this
is the same parameter
that is used in the
+CGDCONT and
+CGDSCONT
commands, the
+CGEQMIN command is
effectively an extension
to these commands. The
QoS profile consists of a
number of parameters,
each of which may be set
to a separate value. In
spite of this, not all
possible combinations
are allowed. See Note 1
on page 3-355.
A special form of the set
command, +CGEQMIN=
<cid> causes the
minimum acceptable
profile for context
number <cid> to become
undefined. In this case no
check is made against the
negotiated profile.
December 31, 2007