Cgsms, Select Service For Mo Sms Messages - Motorola G24 Guide Developer's Manual

+CGSMS, Select Service for MO SMS Messages

This command handles the selection of the service or service preference used by the G24 to send
mobile-originated SMS messages.
Note:
Command
Type
Set
Read
Test
The following table shows the +CGSMS parameters.
<Parameter>
<service>
Example
AT+CGSMS=?
CGSMS:(0-3)
OK
AT+CGSMS?
CGSMS: 1
OK
December 31, 2007
This command is network dependent, which means that the network must support SMS
over GPRS.
Syntax
+CGSMS=[<service>]
+CGSMS?
+CGSMS=?
Table 3-80: +CGSMS Parameters
Indicates the service or service preference to be used.
0 GPRS
1 Circuit switched (default)
2 GPRS preferred (use circuit switched if GPRS is not available)
3 Circuit switched preferred (use GPRS if circuit switched is not available)
Other values are reserved and will result in an ERROR response to the Set command.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
OK The Set command selects the service
or service preference used to send
+CME ERROR: <err>
SMS messages. The value that is set is
not retained after a power cycle.
+CGSMS: <service> The Read command displays the
current SMS service preference
+CME ERROR: <err>
setting.
+CGSMS: (list of The Test command displays a list of
currently available <service>s on the
currently available
network.
<service>s)
+CME ERROR: <err>
Description
Remarks
3-133