Tcp/Ip; Mipcall, Create A Wireless Link - Motorola G24 Guide Developer's Manual

GPRS/EDGE

TCP/IP

+MIPCALL, Create a Wireless Link

This command sets up a PPP (Point to Point Protocol) connection with the GGSN (Gate GPRS
Support Node), and returns a valid dynamic IP for the G24.
Command Type
Set
Read
Test
Note:
Note:
The following table shows the +MIPCALL parameters.
<Parameter>
<status>
"APN"
"User name"
"Password"
Local
IP-address
Note:
3-386
Syntax
+MIPCALL= <Operation> [<APN>,
[<User name>, <Password>]]
+MIPCALL?
+MIPCALL=?
The +MIPCALL command does not return the prompt to the terminal until the IP is
received from the provider, or time out has occurred, therefore, no other commands can
be issued in the meantime.
The +MIPCALL command does not have a general ABORT mechanism, therefore a
command cannot be issued until the previous command ends.
When a call exists the dynamic IP address will be returned.
For example:
AT+MIPCALL?
+MIPCALL: 1,"172.17.237.80"
Table 3-260: +MIPCALL Parameters
0 Disconnect
1 Connected
APN of service provider (in quotation marks). Contact your service provider for
details.
User name in provider server (in quotation marks). Contact your service provider for
details.
Password for provider server (in quotation marks). Contact your service provider for
details.
IP address given by server after PPP negotiation.
The "User name" and the "Password" parameters can be up to 64 characters each.
AT Commands Reference Manual
Response/Action
OK
+MIPCALL: <"local IP address">
or:
ERROR: <err>
+MIPCALL: 0
+MIPCALL: <status>[,<IP>]
+MIPCALL: (list of supported
<operation>s)
Description
December 31, 2007