Tclcc, List Current Calls - Motorola G24 Guide Developer's Manual

+MCST: 3
+MCST: 17
NO CARRIER
+MCST: 1

+TCLCC, List Current Calls

This command displays a list of all current G24 calls and their statuses, and also enables/disables
the unsolicited indication of the call list.
This command is operational only with specific Telematics products.
Operation of this command is flex dependant.
Command
Type
Set
Read
Execute
Test
December 31, 2007
Syntax Response/Action
AT+TCLCC=<state> OK
or:
+CME ERROR: <err>
AT+TCLCC? +TCLCC:<state>
or:
+CME ERROE:<err>
AT+TCLCC +TCLCC:
<idx>,<dir>,<callstate>
,<mode>,<mpty>,[<exit
cause>]
[,<number>,<type>][<
CR><LF>+TCLCC:
<idx>,<dir>,<callstate>
,<mode>,<mpty>,[<exit
cause>]
[,<number>,<type>][...
]]
OK
or:
+CME ERROE:<err>
AT+TCLCC=? +TCLCC: (List of
supported<state>s)
OK
or:
+CME ERROE:<err>
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
Set unsolicited reporting on/off.
Read the current setting.
Read the current call status.
Show list of supported modes.
3-51